|
The Mercury-Redstone Launch Vehicle, designed for NASA's Project Mercury, was the first American manned space booster. It was used for six sub-orbital Mercury flights from 1960–61; culminating with the launch of the first, and 11 weeks later, the second American (and the second and third humans) in space. A member of the Redstone rocket family, it was derived from the U.S. Army's Redstone ballistic missile and the first stage of the related Jupiter-C launch vehicle; but to human-rate it, the structure and systems were modified to improve safety and reliability. The four subsequent Mercury human spaceflights used the more powerful Atlas booster to enter low Earth orbit. == Modifications from the Redstone missile== NASA chose the U.S. Army's Redstone liquid-fueled ballistic missile for its suborbital flights as it was the oldest one in the US fleet, having been active since 1953 and had〔''This New Ocean'', p. 122.〕 many successful test flights.〔''The Mercury-Redstone Project'', p. 2-2, 3-1.〕 The standard military Redstone lacked sufficient thrust to lift a Mercury capsule into the ballistic suborbital trajectory needed for the project;〔 however, the first stage of the Jupiter-C, which was a modified Redstone with lengthened fuel tanks, could carry enough propellant to reach the desired trajectory. Therefore, this Jupiter-C first stage was used as the starting point for the Mercury-Redstone design.〔''The Mercury-Redstone Project'', p. 2-2, 3-1, 4-39 to 4-41.〕 The Jupiter-C's engine, however, was being phased out by the Army, so to avoid potential complications such as parts shortages or design revisions, the Mercury-Redstone designers chose the Rocketdyne A-7 engine used on the latest military Redstones.〔''The Mercury-Redstone Project'', p. 4-41, 9-5.〕 The standard Redstone was fueled with a 75 percent ethyl alcohol 25 percent water solution, but the Jupiter-C first stage had used hydyne fuel, a blend of 60 percent unsymmetrical dimethylhydrazine (UDMH) and 40 percent diethylenetriamine (DETA).〔''The Mercury-Redstone Project'', p. 2-2.〕 This was a more powerful fuel than ethyl alcohol, but it was also more toxic,〔''The Mercury-Redstone Project'', p. 3-2, 4-42.〕 which could be dangerous for an astronaut in a launch pad emergency.〔''The Mercury-Redstone Project'', p. 9-6.〕 Furthermore, hydyne had never been used with the new A-7 engine.〔''The Mercury-Redstone Project'', p. 4-42.〕 The Mercury-Redstone designers rejected hydyne and returned to the standard ethyl alcohol fuel.〔''The Mercury-Redstone Project'', p. 2-2, 3-2, 4-42.〕 The most important change in making the Mercury-Redstone a suitable vehicle for an astronaut was the addition of an automatic in-flight abort sensing system.〔''The Mercury-Redstone Project'', p. 3-2, 9-3.〕 In an emergency where the rocket was about to suffer a catastrophic failure, an abort would activate the launch escape system attached to the Mercury capsule, which would rapidly eject it from the booster. Either the astronaut or the ground controllers could initiate an abort manually,〔''The Mercury-Redstone Project'', p. 5-10, 5-11, 9-4.〕 but some potential failures during flight might lead to disaster before an abort could be manually triggered.〔''The Mercury-Redstone Project'', p. 5-2, 9-4.〕 The Mercury-Redstone's automatic in-flight abort sensing system solved this problem by monitoring the rocket's performance during flight. If it detected an anomaly which might threaten the astronaut, such as loss of flight control, engine thrust, or electrical power, it would automatically abort, shutting down the engine and activating the capsule's escape system.〔''The Mercury-Redstone Project'', p. 5-1, 5-2, 9-4.〕 Ground controllers could not issue a manual shutoff command to the engine until 30 seconds after liftoff to prevent a malfunctioning launch vehicle from coming down on or near the pad.〔''The Mercury-Redstone Project'', p. 3-5, 5-10.〕 An automatic abort could be triggered by any of the following conditions: *Pitch, yaw, or roll angle deviating too far from the programmed flight profile,〔''The Mercury-Redstone Project'', p. 5-3, 5-6, 5-17, 5-19.〕 *Pitch or yaw angle changing too rapidly,〔''The Mercury-Redstone Project'', p. 5-3, 5-6, 5-17, 5-23.〕 *Pressure in the engine's combustion chamber falling below a critical level,〔''The Mercury-Redstone Project'', p. 5-3, 5-6.〕 *Loss of electrical power for the flight control system,〔''The Mercury-Redstone Project'', p. 5-3, 5-6, 5-17.〕 or *Loss of general electrical power (including power for the abort sensing system itself), which could indicate a catastrophic failure.〔''The Mercury-Redstone Project'', p. 5-3, 5-6, 5-10.〕 The range safety system was modified slightly in that a three-second delay would take place between engine cutoff and missile destruct so as to give the escape tower enough time to pull the capsule away.〔''The Mercury-Redstone Project'', p. 4-39, 4-43, 9-7.〕 The most visible difference between the Jupiter-C first stage and the Mercury-Redstone was in the section just below the Mercury capsule and above the propellant tanks. This section was known as the ''aft section'', a term which was inherited from the military Redstone. (The actual rear end of the rocket was called the ''tail section''.) The aft section held most of the Mercury-Redstone's electronics and instrumentation, including the guidance system, as well as the adapter for the Mercury capsule.〔''The Mercury-Redstone Project'', p. 4-5, 4-6, 9-6.〕 In the military Redstone and the Jupiter-C first stage, when the rocket had burned out, its lower portion, containing the rocket engine and propellant tanks, would separate from the aft section and be discarded, and the aft section, with its guidance system, would direct the top half of the rocket during its unpowered ballistic flight. However, in the Mercury-Redstone, the aft section was permanently attached to the lower portion of the rocket.〔''The Mercury-Redstone Project'', p. 3-2, 4-40.〕 When the rocket had shut down, the Mercury capsule would separate from the aft section and would rely on its own guidance. Other changes were made to improve the Mercury-Redstone's reliability. The standard Redstone's ST-80 inertial guidance system was replaced in the Mercury-Redstone with the simpler LEV-3 autopilot. The LEV-3, whose design dated back to the German V-2 missile, was not as sophisticated or as precise as the ST-80, but it was accurate enough for the Mercury mission and its simplicity made it more reliable.〔''The Mercury-Redstone Project'', p. 3-2, 9-7.〕 A special instrument compartment was built in the "aft section" to hold the most important instrumentation and electronics, including the guidance system, the abort and destruct systems, the telemetry instrumentation, and the electrical power supplies. To reduce the chance of failure in this equipment, this compartment was cooled before launch and kept pressurized during flight.〔''The Mercury-Redstone Project'', p. 4-5, 4-41.〕 The space between the pressurized instrument compartment and the capsule was originally intended to hold a parachute recovery system for the rocket. When this system was abandoned, the compartment was used for ballast to improve stability in flight. Unlike the standard Redstone, the Mercury-Redstone's length and heavy payload caused it to become aerodynamically unstable later in the flight as it reached supersonic speeds, but the extra ballast delayed the onset of this effect past the most critical period of maximum aerodynamic forces, known as "max Q". After Mercury-Redstone 1A and Mercury-Redstone 2 exhibited some aerodynamic bending in the adapter section, subsequent flights were equipped with reinforcing bands. The Atlas booster used for orbital Mercury flights had also experienced this issue, but with more catastrophic results as Mercury-Atlas 1 was destroyed in-flight due to structural failure caused by excessive flexing at the point where the booster mated with the capsule adapter.〔''The Mercury-Redstone Project'', p. 3-2, 4-5, 4-21, 4-41.〕 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Mercury-Redstone Launch Vehicle」の詳細全文を読む スポンサード リンク
|